Rudder / Glassing and peel ply

 

Fillets sanded, cloth tape smoothed in and the section cleaned up.

Fiberglass cloth smoothed over the lower sections.

Peel ply smoothed over the glass, this will leave a clean smooth surface and not require too much sanding.

For extra abrasion protection I laid two layers of glass cloth to the underside of the foot and finished with peel ply.

I just love peel ply, once removed it leaves an amine blush free super smooth finish...........did I say I love peel ply?

After filling and sanding a few imperfections, it was time to apply some epoxy coats.

I used a foam roller and applied two coats wet on wet.