Forward Anchor Locker Mod.

 Anchor Chain & Rope Locker Mod,

I decided to add a compartment in the upper starboard bow section between BH 1 and the stem. The compartment will be used to store the anchor rope. The anchor will still be stored on the Port side of the foredeck, this should even the weight distribution. The mod will reduce the buoyancy by approximately a quarter but if I make it watertight and sealed it should still provide some buoyancy. The locker will have a small, hinged sealed access hatch on the foredeck in the area next to the bow sprit forward of BH 1. It will also have a round inspection port in its base to provide access to the bow eye nuts if required which eliminates the access inspection port in BH 1. A simple frame is constructed with cleat timbers and installed at an angle so water can drain from the locker back into the sea. I will add a transom plug to the drain hole to make the locker airtight when sailing.

Cleats are fitted with screws. The centerline cleats run forward to the stem and will sit beneath the lower breast hook.

 

Cardboard templates are made

for the plywood floor and side.

 

An inspection port hole in the floor bottom to provide easy access to the bow eye nuts. 

Here the inspection port is trial fitted.

The base and side are glued into place and held with timber props.

To make the anchor locker airtight and provide buoyancy It needed a screw in plug to seal the chamber when sailing. A 9mm plywood block was cut. The plug was covered with glad wrap.

The plywood block is secured in a vice and epoxy poured around the plug.

Once the epoxy has cured the plug is unscrewed and cleaned up. The block is trial fitted to the inside of the locker.

A drainage hole is drilled through the SB hull, the block is glued into place and held with screws.

I didn't like the size of the drainage hole it aesthetically looked too large, so I formed up a plug from 6mm ply with a smaller hole and glued it into place. It will still allow the locker to drain and looks more in scale with the boat.

The locker receives two layers of undercoat, a 3 to 1, two pack mix.

To maintain the fair curve of the side between BH 1 and the lower breasthook I cut three pieces of 6mm ply that will laminate together to form the cleat.

The laminated pieces are glued and clamped into place on the port and starboard sides between BH 1 and the lower breast hook.

The cleats are cleaned up, the locker is given its final coats of paint and the inspection port that provides access to the bow eye nuts is glued in place.

The lower section of the anchor locker mod is now complete. 

Thats the end of the eighth month of construction.......